Baclyser®

Retrograde
protection on a
higher level

Medical water filters with
MetalSkin Medical® coating

Baclyser®

The Baclyser® S shower head and the Baclyser® TL tap filter are CE-marked medical products. Both disposable point-of-use water filters enclose a hollow fibre membrane with a proven retention efficiency of 7 Log steps for Brevundimonas diminuta. This complies with the FDA definition of sterile filtrated water. All waterborne bacteria such as Pseudomonas and Legionella are blocked by the filter.

  • Safe protection against waterborne bacteria
  • Hygienic design to avoid retrograde contamination
  • Now with up to three months operating time

Baclyser® S

  • Size: L 220 mm, Ø 44 mm
  • Pore size: 0.2 μm
  • Chlorine resistance**: ≤ 10 ppm
  • Flow rate: 10 l/min (at 5 bar, at 30 °C)
  • Connection: G1⁄2ʺ screw thread

Baclyser® TL

  • Size: L 105 mm, H 51 mm, Ø 44 mm
  • Pore size: 0.2 μm
  • Chlorine resistance**: ≤ 10 ppm
  • Flow rate: 10 l/min (at 5 bar, at 30 °C)
  • Connection: Quick-release coupling

Retrograde contamination occurs when microbes
are splashing back from the drain to the water tap.

Therefore the MetalSkin Medical® coating was developed. This is a resin-polymer casting with a 92 % copper alloy, which has an bacteriocidal effect. MetalSkin Medical® is designed to fight retrograde contamination caused by aerosols and splash water from the drain and water basins. Tested through ISO standard 22196 and also NF S90-700 it has proven its outstanding performance in killing 99 % of bacteria in three minutes and 99.5 % of SARS-CoV-2 within 4 hours.

For further information about Baclyser® and MetalSkin Medical® visit www.aqua-free.com/en